HPE2-W09 Practice Exam Questions and Answers

Is this a rule for configuring schedule profiles on an ArubaOS-CX switch?

Solution:With the exception of a single strict priority queue, all queues must use the same scheduling algorithm.

Does this correctly describehow the Virtual Switching Extension (VSX) fabric reacts to various component failure scenarios?

Solution:The keepalive goes down, ISL link remains up. Switch-1 and Switch-2 remains up. The Split-recovery mode is disabled. In this case the secondary switch shutdowns Svls.

You are using NetEdit to manage AruDaOS-CX switches. You want to deploy a standard config to the switches, but need the config to include a few device-specific settings such as hostname and IP address.

Is this what you should do?

Solution:omit the device-specific settings from the configuration plan and include them in command scripts instead.

You plan to use multi-protocol BGP to implement dynamic VRF route leaking on an ArubaOS-CX switch.

Is this a rule for the setup?

Solution:You can only leak routes between up to three VRFs.

You plan to use multi-protocol BGP to implement dynamic VRF route leaking on an ArubaOS-CX switch.

Is this a rule for the setup?

Solution:You cannot leak multicast routes.

You ate using NetEdit to manage AruDaOS-CX switches. You want to deploy a standard conflg to the switches, but need the config to include a few device-specific settings such as hostname and IP address.

Is this what you should do?

Solution:Instead of using a standard configuration plan to deploy the configuration, create an auto config plan that uses scripts.

Refer to the exhibits.

Is this how the switch-1handles the traffic?

Solution:A broadcast arrives in VLAN 10 on Switch-1. Switch 1 forwards the frame on all interfaces assigned to VLAN10. except the incoming interface. It replicates the broadcast, encapsulates each broadcast with VXLAN. and sends the VXLAN traffic to 192.168.1.2 and 192.168.1.3.

Is this a use case for deploying Ethernet Ring Protection Switching (ERPS)?

Solution:connecting multiple data centers at Layer2while minimizing the number of dark fiber connections required

Refer to the exhibit.

Refer to the exhibit.

You are adding a VLAN 30, subnet 10.0.30.0/24 to the network shown in the exhibit. (This network is simplified to just the relevant switches for this item.) This subnet belongs in VRF A, and you have added a Layer 3 VLAN 30 interface attached to this VRF on Switch-1. You want to make the services in this VLAN available to devices in 10.1.20.0/24 in VRF

B.  

Is this part of a valid setup for meeting these requirements?

Solution:Add VRF B as the secondary VRF on VLAN interface 30.

Is this a best practice when positioning ArubaOS-CX switches in data center networks?

Solution:Deploy Aruba CX 83xx switches as data center spine switches.

Does this correctly describethe ArubaOS-CX architecture?

Solution:The AtubaOS-CX software is based on the ArubaOS-Switch software and adds data center features.