MTCNA Practice Questions

To configure a PPPoE client on MikroTik, you need to:

Set the client interface (usually ether1 or another WAN-facing port).

Optionally add NAT masquerading to enable LAN users to reach the internet.

IP address on the interface is assigned dynamically from the ISP after PPPoE negotiation, so a static IP is not required.

Option Analysis:

A.  

✔Required – You must select the interface that initiates the PPPoE connection.

B.  

✘Not Required – The IP is typically assigned by the PPPoE server (ISP).

C.  

✔Required – NAT masquerade is commonly used to allow internet access for private IP clients behind the router.

Extract from MTCNA Course Material – PPPoE Client Setup:

“The PPPoE client must have an interface specified. A NAT masquerade rule is recommended for internet access sharing.”

Extract from René Meneses MTCNA Study Guide – PPPoE:

“You do not need to assign a static IP to the PPPoE client interface. IP is received after successful login.”

Extract from MikroTik Wiki – PPPoE Client:

“After setting up the interface and credentials, PPPoE client negotiates and receives dynamic IP. Add NAT if routing LAN traffic.”

===========