300-410 Practice Questions
Implementing Cisco Enterprise Advanced Routing and Services (300-410 ENARSI)
Last Update 4 days ago
Total Questions : 642
Dive into our fully updated and stable 300-410 practice test platform, featuring all the latest CCNP Enterprise exam questions added this week. Our preparation tool is more than just a Cisco study aid; it's a strategic advantage.
Our free CCNP Enterprise practice questions crafted to reflect the domains and difficulty of the actual exam. The detailed rationales explain the 'why' behind each answer, reinforcing key concepts about 300-410. Use this test to pinpoint which areas you need to focus your study on.
A customer is running an mGRE DMVPN tunnel over WAN infrastructure between hub and spoke sites. The existing configuration allows NHRP to add spoke routers automatically to the multicast NHRP mappings. The customer is migrated the network from IPv4 to the IPv6 addressing scheme for those spokes’ routers that support IPv6 and can run DMVPN tunnel over the IPv6 network. Which configuration must be applied to support IPv4 and IPv6 DMVPN tunnel on spoke routers?
A screen shot of a computer AI-generated content may be incorrect.
A screen shot of a computer AI-generated content may be incorrect.
Refer to the exhibit.
Packets arriving from source 209.165.200.215 must be sent with the precedence bit set to 1, and packets arriving from source 209.165.200.216 must be sent with the precedence bit set to 5. Which action resolves the issue?
Refer to the exhibit. Users are experiencing slow response times from critical application servers connected to the network. The engineer determined from the console log that there is a DOS attack on the interface GigabitEthernet0/0. Which action must the engineer take to resolve the issue?
Refer to the exhibit.
After a security audit, the administrator implemented an ACL in the route reflector. The RR became unreachable from any router in the network. Which two actions resolve the issue? (Choose two.)
Refer to the exhibit. An engineer configured two ASBRs, 10.4.17.6 and 10.4.15.5, in an OSPF network to redistribute identical routes from BGR However, only prefixes from 10.4.17.6 are installed into the routing table on R1. Which action must the engineer take to achieve load sharing for the BGP-originated prefixes?
Refer to the exhibit. Bangkok Is using ECMP to reach the 172.20.2.0/24 network. The network administrator must configure. It in such a way that traffic from 172.16.2 0/24 network uses the Singapore router as the preferred route. Which set of configurations accomplishes this task?
A)
B)
C)
D)
Refer to the exhibit. Router R1 peers with two ISPs using static routes to get to the internet. The requirement is that R1 must prefer ISP-A under normal circumstances and failover to ISP-B if the connectivity to ISP-A is lost. The engineer observes that R1 is load balancing traffic across the two ISPs Which action resolves the issue by sending traffic to ISP-A only with failover to ISP-B?
A network administrator is tasked to permit http and https traffic only toward the internet from the User1 laptop to adhere to company’s security policy. The administrator can still ping to www.cisco.com Which interface should the access list 101 be applied to resolve this issue?
Refer to the exhibit.
An engineer configures SW101 to send OSPFv3 interfaces state change messages to the server. However, only some OSPFv3 errors are being recorded. which organization resolves the ..?
Refer to the exhibit.
BGP and EIGRP are mutually redistributed on R3, and EIGRP and OSPF are mutually redistributed on R1. Users report packet loss and interruption of service to applications hosted onthe 10.1.1.0724 prefix. An engineer tested the link from R3 to R4 with no packet loss present but has noticed frequent routing changes on R3 when running the debug ip route command. Which action stabilizes the service?
Refer to the exhibit. The remote server is failing to receive the NetFlow data Which action resolves the issue?
Refer to the exhibit. R2 has two paths to reach 192.168.13.0/24. but traffic is sent only through R3. Which action allows traffic to use both paths?
