Pre-Summer Sale Limited Time 65% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: 65pass65

4A0-103 Alcatel-Lucent Multi Protocol Label Switching is now Stable and With Pass Result | Test Your Knowledge for Free

Exams4sure Dumps

4A0-103 Practice Questions

Alcatel-Lucent Multi Protocol Label Switching

Last Update 23 hours ago
Total Questions : 249

Dive into our fully updated and stable 4A0-103 practice test platform, featuring all the latest SRC Certification exam questions added this week. Our preparation tool is more than just a Nokia study aid; it's a strategic advantage.

Our free SRC Certification practice questions crafted to reflect the domains and difficulty of the actual exam. The detailed rationales explain the 'why' behind each answer, reinforcing key concepts about 4A0-103. Use this test to pinpoint which areas you need to focus your study on.

4A0-103 PDF

4A0-103 PDF (Printable)
$43.75
$124.99

4A0-103 Testing Engine

4A0-103 PDF (Printable)
$50.75
$144.99

4A0-103 PDF + Testing Engine

4A0-103 PDF (Printable)
$63.7
$181.99
Question # 11

Which of the following LDP message categories is UDP-based?

Options:

A.  

Notification

B.  

Session

C.  

Discovery

D.  

Advertisement

Discussion 0
Question # 12

Click on the exhibit button below.

Question # 12

Under which condition might the peer LDP ID 10.10.10.2:0 entry show state "Nonexistent"?

Options:

A.  

When the interface to the peer router is down.

B.  

When router R1 has no route to the peer address 10.10.10.2.

C.  

When the adjacency between the two routers fails.

D.  

When the targeted session is not yet configured.

Discussion 0
Question # 13

An Alcatel-Lucent 7750 SR enabled with LDP has multiple equal cost paths to a given FE

C.  

After ECMP is enabled, which of the following is FALSE?

Options:

A.  

The router has new entries added for the given FEC in its LI

B.  

B.  

The router has new entries added for the given FEC in its FI

B.  

C.  

The router generates a single label for the given FEC and advertises it to all its peers,

D.  

The router has multiple LSP tunnels for the given FE

C.  

Discussion 0
Question # 14

Which of the following about the RSVP-TE Hello protocol is FALSE?

Options:

A.  

The Hello protocol can speed up convergence without reducing refresh time.

B.  

Hello messages are sent after at least one RSVP session is active on the interface.

C.  

An interface with multiple RSVP sessions sends Hello messages for each session.

D.  

An RSVP neighbor is declared down if Hello messages are not received within the Hello timeout.

Discussion 0
Question # 15

Click on the exhibit button below. Assume the following:

Question # 15

- Each router's OSPF interfaces are in the areas shown.

- Bidirectional LDP-over-RSVP tunnels extend from routers R1 to R3 and back over the path R1-R4-R5-R3.

- You enable fast reroute facility bypass on the R5-R3 RSVP LSP.

- Router R5 acts as a PLR, protecting the R5-R3 link by building a bypass tunnel through router R2.

You build a layer 2 VPN on routers R1 and R3, using the LDP-over-RSVP tunnels. What MPLS configuration step must you complete on router R2 for it to protect the end-to-end service?

Options:

A.  

Enable LDP on the R2-R5 interface.

B.  

Configure T-LDP sessions between routers R2 and R5 and R3.

C.  

Configure LDP-over-RSVP support on router R2.

D.  

Enable MPLS and RSVP on the router R2 network interfaces.

E.  

Enable LDP on the R2-R5 and R2-R3 interfaces.

Discussion 0
Question # 16

Click on the exhibit.

Question # 16

Under which condition might the peer entry with an LDP ID of 10.10.10.2:0 show the state "Nonexistent"?

Options:

A.  

When the interface to the peer router is down.

B.  

When router R1 has no route to the peer address 10.10.10.2.

C.  

When LDP is not configured on the peer router's interface.

D.  

When the targeted session is not configured.

Discussion 0
Question # 17

Which of the following LDP messages are used in the successful establishment of LDP sessions? Choose three answers

Options:

A.  

Label request message

B.  

Notification message

C.  

Address message

D.  

Keepalive message

E.  

Initialization message

F.  

Hello message

Discussion 0
Question # 18

Two directly connected routers set different interface Hello timeout values. Router R1 uses 15 seconds, while router R2 uses 30 seconds. Which of the following best describes the LDP adjacency?

Options:

A.  

The adjacency forms with the lower timeout value.

B.  

The adjacency forms with the higher timeout value.

C.  

The adjacency is in init state.

D.  

The adjacency times out after 30 seconds.

Discussion 0
Question # 19

Which of the following devices receives labeled packets from the MPLS domain, removes the MPLS header, and forwards unlabeled packets outside the MPLS domain?

Options:

A.  

P router

B.  

LSR

C.  

eLER

D.  

iLER

Discussion 0
Question # 20

When a device receives a labeled packet, which of the following can occur?

Options:

A.  

The packet can only be forwarded as an unlabeled packet.

B.  

The packet can be forwarded as a labeled or unlabeled packet, depending on the received label value.

C.  

The packet can be forwarded as a labeled or unlabeled packet, depending on the destination IP address in the payload

D.  

The packet can only be forwarded as a labeled packet.

Discussion 0
Get 4A0-103 dumps and pass your exam in 24 hours!

Free Exams Sample Questions