Free Alcatel-Lucent Multi Protocol Label Switching Practice Questions

A.  

It makes use of MPLS resiliency features available within an AS.

B.  

It eliminates double route lookups on all routers within an AS.

C.  

It eliminates the need to run IGP on all routers within an AS.

D.  

It eliminates the need for an iBGP full mesh on all core routers.

A.  

R1-R2 will have 300Mbps left and R2-R4 will have 400Mbps left.

B.  

R1-R2 will have 400Mbps left and R2-R4 will have 400Mbps left.

C.  

R1-R2 will have 600Mbps left and R2-R4 will have 600Mbps left.

D.  

R1-R2 will have 300Mbps left and R2-R4 will have 600Mbps left.

A.  

The secondary path will take R1-R3-R2-R4-R6.

B.  

The secondary path will take R1-R2-R4-R6.

C.  

The secondary path will take R1-R2-R3-R5-R6.

D.  

The secondary path will take R1-R3-R2-R4-R5-R6.

A.  

RSVP-TE supports Connection Admission Control (CAC).

B.  

RSVP-TE enables simplified configuration of LSPs.

C.  

RSVP-TE supports path calculations that do not use IGP cost.

D.  

RSVP-TE provides support for traffic protection features.

A.  

The PLR attempts to provide link protection.

B.  

The PLR disregards the request after three failed attempts.

C.  

The PLR changes the PATH message to request link protection.

D.  

The PLR brings down the primary LSP-path.

A.  

Admin groups

B.  

Hop-limit

C.  

Strict hops

D.  

TE-Metric

A.  

LDP is not configured on R2.

B.  

R2 does not have a route to 10.10.10.3.

C.  

LDP is not configured on R3's interface to R2.

D.  

The targeted session is not configured on R2.

A.  

Configure BGP with the IPv6 address family.

B.  

Configure BGP to add IPv6 Explicit Null labels.

C.  

Configure a route policy to export IPv6 routes into BGP.

D.  

Configure the nexthop core router as a BGP peer.

A.  

RRO is used to report the protection tunnel status to the head-end router.

B.  

RRO contains the MP information that is required by a PLR for facility protection.

C.  

RRO contains the label information that is expected by an MP for facility protection.

D.  

RRO is used to inform downstream routers about the protection type requested.

A.  

LSPs must always terminate on a system I

D.  

B.  

MPLS and RSVP must be enabled on all LSRs.

C.  

CSPF must be enabled.

D.  

Path definitions must include at least one hop entry.