JN0-664 Practice Questions

A.  

There is a mismatch in the hello interval parameter between routers R1 and R2

B.  

There is a mismatch in the dead interval parameter between routers R1 and R2.

C.  

There is a mismatch in the OSPF hold timer parameter between routers R1 and R2.

D.  

There is a mismatch in the poll interval parameter between routers R1 and R2.

A.  

Routers with receivers send join messages to their upstream neighbors.

B.  

Routers without receivers must periodically prune themselves from the SPT.

C.  

Traffic is initially flooded to all routers and an S,G is maintained for each group

D.  

Traffic is only forwarded to routers that request to join the distribution tree.

A.  

All Type 2 and Type 7 LSAs will be summanzed into a single Type 5 LSA

B.  

The area-range command must be installed on all routers.

C.  

Type 3 LSAs are advertised for routes in Type 1 LSAs.

D.  

The metric associated with a summary route will be equal to the lowest metric associated with an individual contributing route

A.  

It uses a remote triggered black hole to protect a network from a denial-of-service attack.

B.  

It uses dynamically created routing policies to protect a network from denial-of-service attacks

C.  

It is used to protect a network from denial-of-service attacks dynamically

D.  

It verifies that the source IP of the incoming packet has a resolvable route in the routing table

A.  

Change the bootstrap priority on R2 to be higher than R3

B.  

Change the default route in inet.2 on R4 from R3 as the next hop to R2

C.  

Change the local address on R2 to be higher than R3.

D.  

Change the group-range to be more specific on R2 than R3.

A.  

CSNPs are flooded periodically.

B.  

PSNPs are flooded periodically.

C.  

PSNPs contain only descriptions of LSPs.

D.  

CSNPs contain only descriptions of LSPs.

A.  

R2 is missing internal routes for R1.

B.  

R1 is missing internal routes for R2.

C.  

R3 does not have wide-metrics enabled.

D.  

R1 does not have wide-metrics enabled.

A.  

The NSEL byte for Area 0001 is 00.

B.  

The area address is two bytes.

C.  

The routers are using unnumbered interfaces

D.  

The system IDofR1_2 is 192.168.16.1

A.  

Configure remove-private on advertisements from AS 64497 toward AS 64498.

B.  

Configure as-override on advertisement from AS 64500 toward AS 64512.

C.  

Configure remove-private on advertisements from AS 64500 toward AS 64499.

D.  

Configure loops and advertise-peer-as on routers in AS 64497 and AS 64450.

E.  

Configure loops on routers in AS 65412 and advertise-peer-as on routers in AS 64498.

A.  

You must use RIB groups to leak routes between the inet. o and vpn-a. inet. o tables.

B.  

RIB groups are not needed to leak routes between the inet. 0 and VPN—

A.  

C.  

Internet traffic from Site 2 takes the path of PE-2 -> PE-1 -> GW-1.

D.  

Internet traffic from Site 2 takes the path of PE-2 -> PE-1 -> CE-1 -> PE-1 -> GW-1.