An administrator has recently completed the initial configuration of Nutanix Disaster Recovery for a production environment. Protection Policies and Recovery Plans have been configured and validated by the senior infrastructure team.
The administrator has confirmed that the expected categories are correctly associated with both the Protection Policies and Recovery Plans. During a scheduled test failover, the administrator notices that several VMs are missing from the recovery.
The administrator reviews the environment and notes the following:
The Protection Summary tab does not show any warnings or errors
No replication tasks are currently ongoing
The missing VMs were all deployed within the last two weeks as part of a new application rollout
The missing VMs are running on the same cluster as other VMs that recovered successfully during the test failover
The application team followed the standard VM deployment checklist but did not coordinate with the infrastructure team during provisioning
Given this information, what is the most likely cause of the missing VMs?
An administrator notices that storage utilization continues to increase at both the primary and recovery sites after implementing a third-party backup solution that uses protection policies. Which configuration should be reviewed first?
Refer to Exhibit:
An administrator is configuring Metro Availability in their environment, as shown in the diagram. What issue in the configuration will prevent Metro from working correctly?
In the case of a protection domain containing more than 500 VMs, what is the first step an engineer must take before migrating to Prism Central-based protection policies while ensuring all VMs remain protected?
An administrator initiates an unplanned failover due to a primary AZ outage. What is the worst-case scenario for data loss and which recovery point will be used by default?
A third-party backup solution is configured to use Nutanix application-consistent snapshots. Backups are failing for several Windows VMs, although crash-consistent snapshots succeed.
What is the most likely cause of the failure?
An administrator logs into Prism Central (PC) and notices that a replication of a recovery point is still ongoing from Cluster A to Cluster B on a new setup.
The bytes being replicated aren ' t changing.
Both site ' s virtual IP addresses are reachable.
Connectivity between PC/PE is good.
There is a dedicated LAN between the clusters.
What could be causing this replication to be stuck?
What must the maximum Round Trip Latency be less than between a Witness VM and Metro Availability PDs?
An administrator is evaluating Nearsync for critical VMs in a Nutanix Disaster Recovery environment. What is the minimum RPO, in minutes, supported by Nearsync replication?
An organization has two Nutanix clusters managed by a single Prism Central (PC) instance. They intend to implement Synchronous Replication between the sites. During a failover test, the administrator notices that automatic failover does not occur when the primary site ' s storage becomes unavailable. What is the most likely cause of this behavior based on an analysis of the requirements?
