Pre-Winter Sale Limited Time 65% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: 65pass65

Free FortiGate 7.6 Administrator FCP_FGT_AD-7.6 Practice Questions

Question # 11

A network administrator enabled antivirus and selected an SSL inspection profile on a firewall policy.

When downloading an EICAR test file through HTTP, FortiGate detects the virus and blocks the file. When downloading the same file through HTTPS, FortiGate does not detect the virus and does not block the file, allowing it to be downloaded.

The administrator confirms that the traffic matches the configured firewall policy.

What are two reasons for the failed virus detection by FortiGate? (Choose two.)

Options:

A.  

The selected SSL inspection profile has certificate inspection enabled.

B.  

The website is exempted from SSL inspection.

C.  

The El CAR test file exceeds the protocol options oversize limit.

D.  

The browser does not trust the FortiGate self-signed CA certificate.

Discussion 0
Question # 12

An administrator wants to configure dead peer detection (DPD) on IPsec VPN for detecting dead tunnels. The requirement is that FortiGate sends DPD probes only when there is no inbound traffic.

Which DPD mode on FortiGate meets this requirement?

Options:

A.  

Enabled

B.  

On Idle

C.  

Disabled

D.  

On Demand

Discussion 0
Question # 13

Refer to the exhibits.

Question # 13

An administrator has observed the performance status outputs on an HA cluster for 55 seconds.

Which FortiGate is the primary?

Options:

A.  

HQ-NGFW-2 with the parameter memory-failover-threshold setting

B.  

HQ-NGFW-2 with the parameter priority setting

C.  

HQ-NGFW-1 with the parameter memory-failover-flip-timeout setting

D.  

HQ-NGFW-1 with the parameter override setting

Discussion 0
Question # 14

Refer to the exhibits.

Question # 14

The exhibits show a diagram of a FortiGate device connected to the network, and the firewall configuration.

An administrator created a Deny policy with default settings to deny Webserver access for Remote-User2.

The policy should work such that Remote-User1 must be able to access the Webserver while preventing Remote-User2 from accessing the Webserver.

Which additional configuration can the administrator add to a deny firewall policy, beyond the default behavior, to block Remote-User2 from accessing the Webserver?

Options:

A.  

Disable match-vip in the Allow_access policy

B.  

Configure a One-to-One IP Pool object in a new policy.

C.  

Set the Destination address as Webserver in the Deny policy.

D.  

Set the Destination address as Deny_IP in the Allow_access policy.

Discussion 0

FCP_FGT_AD-7.6 PDF

FCP_FGT_AD-7.6 PDF (Printable)
$54.25
$154.99

FCP_FGT_AD-7.6 Testing Engine

FCP_FGT_AD-7.6 PDF (Printable)
$59.5
$169.99

FCP_FGT_AD-7.6 PDF + Testing Engine

FCP_FGT_AD-7.6 PDF (Printable)
$74.55
$212.99

Free Exams Sample Questions