Spring Sale Limited Time 65% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: 65pass65

CTAL-TM Certified Tester Advanced Level Test Management (CTAL-TM) v3.0 is now Stable and With Pass Result | Test Your Knowledge for Free

Exams4sure Dumps

CTAL-TM Practice Questions

Certified Tester Advanced Level Test Management (CTAL-TM) v3.0

Last Update 3 months ago
Total Questions : 228

Dive into our fully updated and stable CTAL-TM practice test platform, featuring all the latest Test Manager Advanced exam questions added this week. Our preparation tool is more than just a ISTQB study aid; it's a strategic advantage.

Our free Test Manager Advanced practice questions crafted to reflect the domains and difficulty of the actual exam. The detailed rationales explain the 'why' behind each answer, reinforcing key concepts about CTAL-TM. Use this test to pinpoint which areas you need to focus your study on.

CTAL-TM PDF

CTAL-TM PDF (Printable)
$43.75
$124.99

CTAL-TM Testing Engine

CTAL-TM PDF (Printable)
$50.75
$144.99

CTAL-TM PDF + Testing Engine

CTAL-TM PDF (Printable)
$63.7
$181.99
Question # 51

Which one of the following will allow phase containment to be assessed within a testing project? SELECT ONE OPTION

Options:

A.  

Using the phases of defect introduction and detection data for all phases of the project.

B.  

Using the phases of defect introduction, detection and removal data on a phase by phase basis.

C.  

Using defect introduction and removal data for the project as a whole.

D.  

Using defect removal data for the testing phases of the project.

Discussion 0
Question # 52

Which of the following is likely to occur if reviewers do not have an adequate level of technicalknowledge? [1]

Options:

A.  

There will be no impact as long as they have sufficient business knowledge.

B.  

There will be no impact as long as they have sufficient process knowledge.

C.  

The review is likely to be less efficient.

D.  

The review will be shorter because any technical aspect can be skipped.

Discussion 0
Question # 53

The test team is using a distributed model for testing.

What is the primary factor you should consider with this model? [1]

Options:

A.  

Alignment of methodologies

B.  

Co-location of test team

C.  

Provision of growth opportunities for the individual testers

D.  

Planned vs. actual hours

Discussion 0
Question # 54

Which of the following is a typical use of risk analysis? [1]

Options:

A.  

Identifying the appropriate depth of testing for each identified risk

B.  

Deciding what personnel should be assigned to which tests

C.  

Determining the design of the tests used to mitigate each identified risk

D.  

Forecasting the product delivery date

Discussion 0
Question # 55

Which of the following metrics is MOST LIKELY to trigger a control directive to increase test execution resources?

Options:

A.  

Percentage of manual test cases by their execution status, showing that the number of tests run is less than planned

B.  

Percentage of test cases that have been automated, showing that this is less than planned

C.  

Percentage of test cases by their execution status, showing that the number of failures is greater than expected

D.  

Percentage of test environment availability during scheduled hours, showing that this is less than planned

Discussion 0
Question # 56

A car rental company offers discounts to its customers based on a number of factors, including booking history, length of membership and type of car being booked. An update to the rental application is under test, with test cases written that specifically address a documented product risk covering discount calculation. Although the risk impact was analysed as high, the likelihood was given as low, as there had been no known changes to the calculation rules. However, during test execution some discount calculations were incorrect and investigation showed that code changes had been made that impacted the discount algorithms. As a result, the likelihood was increased to high by the risk management team.

Which would be the BEST measure to take to respond to the current situation?

Options:

A.  

Monitor the risk and adjust the risk register to reflect the changed risk level and any new risksdiscovered

B.  

Update the test case coverage of the discount calculation risk to reflect the increased risk level

C.  

Review the composition of the risk management team to ensure a better diversity of stakeholders

D.  

Adopt a risk-based testing strategy to help mitigate failures in the rental application

Discussion 0
Question # 57

The previous release of an in-house invoicing application was live for 6 months before beingreplaced by a later release.

• Before it went live, €1,500 had been spent on defect prevention and a further €4,500 had been spent on writing and running tests; these tests found 80 defects and the average cost of dealing with these was €50 each.

• By the time that it was replaced, defect reports from live running showed that pre-release testing had found only 80% of the defects that were present; the average cost of dealing with the defects that went live was 12 times that of the internal failures.

Which statement is TRUE?

Options:

A.  

Neither external failure costs nor total Cost of Quality can be calculated from the available data

B.  

The external failure costs were €13,000 and the total Cost of Quality was €23,000

C.  

Each defect found before release saved an average of €600

D.  

The external failure costs were €12,000 and the total Cost of Quality was €22,000

Discussion 0
Question # 58

Your company just won a contract to create a new sales application and has committed to a very aggressive delivery timeline. Due to the quick turnaround your primary stakeholder wants to be

heavily involved in the design and is very anxious to see the outcome. Because of this, your company has decided to use a spiral development approach. You have a defined test policy and

typically use an analytical approach to testing, however, this approach will not work with the development approach.

What test strategy should be utilized? [3]

Options:

A.  

Model-based

B.  

Methodical

C.  

Standard-compliant

D.  

Reactive

Discussion 0
Question # 59

Which technique will assist you in determining targeted improvement areas to reduce the number of defects? [1]

Options:

A.  

Cost of quality analysis

B.  

Defect triage

C.  

Pareto analysis

D.  

Test coverage assessment

Discussion 0
Question # 60

Mary is an external IT auditor. She is conducting a review of the system-level testing done by Greg's functional testing team.

Which of the following items from Mary's assessment summary should concern Greg the most? [2]

Options:

A.  

All the Business requirements could be traced to Test Objectives. However there was no tracing from the Business Requirements to the project's test

schedule.

B.  

Some of the Test Objectives could only be mapped back to a single Business Requirement.

C.  

A few of the Test Objectives did not have any Test Conditions assigned to them.

D.  

There were Test Conditions which didn't tie back to any Business Requirement.

Discussion 0
Get CTAL-TM dumps and pass your exam in 24 hours!

Free Exams Sample Questions