On the OSPF network shown in the figure, area 1 is a common area, area 2 is a stub area, and area 3 is an NSS
A.
R5 imports an external route 10.0.5.5/32. Given this, which of the following routers does not have the route 10.0.5.5/32 in its routing table?
The path that IP packets pass through on an MPLS network is called a label switched path (LSP). An LSP is a bidirectional path that specifies the transmission direction of data flows.
If technology migration on the network affects the services running on the live network, strictly follow the preset operation process and risk control measures during the implementation of the technology migration project. Generally, this type of project is defined as a migration project. Which of the following operations performed on the live network belongs to a non-migration project?
On the OSPFv3 network shown in the figure:
OSPFv3 is enabled on the interfaces connecting R1, R2, and R3.
The router ID of each router is 10.0.X.X, where X is the number of the router.
When checking detailed information about an LSA on R3, the command output shows that the LSA is generated by R2 and describes the IPv6 prefix address associated with the Network-LS
A.

Based on this information, which of the following statements is correct?
Which of the following is not added for IS-IS to support IPv6 route processing and calculation?
The source IP address of IS-IS Hello packets is changed to the link-local address.
TLV 232, which is equivalent to the IP Interface Address TLV in IPv4, except that the original 32-bit IPv4 address is changed to a 128-bit IPv6 address.
The AS Path attribute is the private attribute of BGP. The if-match as-path-filter command is applicable only to BGP routes
By default, a P2P or broadcast interface sends OSPF Hello packets at an interval of 10s, and the neighbor dead interval is 40s.
There are multiple types of MAC address entries on a switch. Which of the following entries are manually configured and cannot be aged out?
VLAN aggregation is configured on a switched network. Sub-VLAN 2 and Sub-VLAN 3 are added to Super-VLAN 10. To enable hosts in different sub-VLANs to communicate with each other, run the following command in the VLANIF 10 view corresponding to the Super-VLAN.
(Enter lowercase letters.)
On a BGP/MPLS IP VPN network, _ _ is used to distinguish IPv4 prefixes with the same address space. In this case, IPv4 addresses are called VPNv4 addresses. (Enter the acronym in uppercase.)
