In the hub-spoke networking shown in the figure, the Hub-PE can be configured to allow repetitive local AS numbers for correct route transmission.

In CE multi-homing scenarios, if BGP AS number substitution is enabled on PEs, you can run the peer soo command on the EBGP peers of the PEs and CE to configure the Site of Origin (SoO) attribute to prevent loops.
On the network shown in the figure, R1 and R2 cannot establish an EBGP peer relationship through directly connected interfaces. To locate this fault, a network engineer checks BGP configurations on R1 and R2, as shown in the figure. Based on these configurations, it can be determined that the fault cause is the inconsistent router IDs and interface IP addresses.

