On the OSPF network shown in the figure, area 1 is an NSSA, area 2 is a common area, and R4 imports an external route 10.0.4.4/32. The router ID of each router is 10.0.X.X, where X is the number of the router. The command asbr-summary 10.0.4.0 255.255.255.0 is configured in the OSPF processes of R1 and R3. Which of the following statements is true?

For high reliability purposes, the following LDP messages are transmitted through TCP: discovery messages, session messages, advertisement messages, and notification messages.
An enterprise network engineer wants to configure VLAN aggregation and MUX VLAN to conserve IP addresses and restrict communication at Layer 2. To conserve VLAN resources, the engineer can configure the same VLAN ID for the super-VLAN and MUX VLAN.
Service routes of an enterprise are transmitted on the network. Some configurations of PE1 and PE2 are shown in the figure. Which of the following LSAs may CE2 receive?

OSPF supports equal-cost load balancing. When the number of equal-cost routes on the network is greater than the number specified in the maximum load-balancing command and the candidate routes have the same priority (weight value), the routes with larger interface indexes are selected for load balancing.
If end-to-end QoS is configured on an MPLS network, the penultimate hop device on the MPLS network can pop MPLS labels from packets based on penultimate hop popping (PHP), so that the egress node can process packets based on the QoS priority in inner packets.
Network administrators can run the clock timezone command to set the time zone of a device. If two network devices have different time zone settings, they cannot establish a neighbor relationship using a dynamic routing protocol.
Options:
A device upgrade is required for incorporating new features, optimizing performance, and resolving problems in the current version. To upgrade a device, load the system software of the target version and restart the device. Huawei NetEngine AR series devices, such as AR6120, AR6280, and AR6000V, use the same software package.
On the OSPF network shown in the figure, R1 and R2 are connected through four links. OSPF is enabled on Loopback0 of R2, and the maximum load-balancing 1 command is run in the OSPF process of R1. Which of the following is the outbound interface from R1 to Loopback0 of R2?

An administrator runs the display mpls Isp command to view LSPs on a device. The command output is shown in the figure. Which of the following statements are true?

